Last updated: 31/08/2020
AutoSmoke continuously produces clouds of smoke in an outwards, circular arrangement.
Click the image above to see it in full
1. Go to 'accessory manipulation' and click 'load'.
2. Select AutoSmoke.x and click 'OK'.
Accessory Parameter Values
-X, Y, Z, Rx, Ry, Rz: Adjusts the placement and rotation of the overall smoke cluster.
-Si: Adjusts the size of the overall smoke cluster.
-Tr: Adjusts the transparency of the smoke clouds.
Editing the Code Parameters
-Line 6: ParticleNum: Dictates the numbers of smoke clouds produced on the outer ring.
-Line 7: Particle2Num: Dictates the number of smoke clouds produced on the inner ring.
-Line 10: AnmSpd: Determines the speed at which the smoke clouds move. The greater the value, the faster they will move.
-Line 27: particleSize: Determines the size of the individual smoke clouds.
-Line 29: RotateSpd: Determines the speed at which the individual smoke clouds rotate. \Need confirmation on this one.
-Line 31: ScaleSpd: Determines the speed at which the individual smoke clouds shrink before fading away.
-There is an area in the center of the smoke cluster where the smoke clouds do not spawn. This area is increased if the Si value is increased.